Digital kiln controller glass blowing glassblowing Ramp & soak Turn any kiln into a glass kiln 110 or 220 Start Price USD 300.00 Current Price USD 300.00 Time Left - Bid Count 0 Buy It Now Price USD 350.00 Reserve Price - Start Time Monday, September 01, 2008 End Time Monday, September 08, 2008 Location SW FLA See more about 'Digital kiln controller glass blowing glassblowing ' Description Pic shows other control head, This auction will include a Omega control head (which the control head alone retails at $500 ( thats with out the housing, relay, heat sink, thermocouple, plugs ect) We purchased the remaing stock from a company that was closing and were able to secure a doz of these control heads for far under wholesale cost) The controller will lock the same but with an omega controller. Not shown is thermcouple, plug and receptical. This will allow you to turn any kiln into a glass kiln. ( this controller is ment for boro or soft glass blowers. If needing it for other use, please let me know and we can list one that will meet you exact needs) This auction is for a 110/120 volt kiln. ( 220 -240V) avaliable for $30-$50 more ( depending on the plug/receptical that is needed)  Omega single program ramp and soak or can be used as digital set piont. For use in any kiln. Includes controller wired ready to plug and go  ( includes thermocouple, plug, receptical, relay, heat sink, houseing ect)  I will add more to this listing tonight ( fri night) Payment must be received with in 7 days of auction end. Personal checks must clear prior to shipping. Paypal and money orders are also accepted. If you have less than 5+ feedback please contact me prior to bidding. Please do not bid if you do not plan on completing the transaction. All non-paying bidders will receive negative feedback and be reported to ebay. International bidders please contact me prior to bidding  Multiple purchases can be combined to save on shipping.On Aug-31-08 at 08:19:53 PDT, seller added the following information: All controllers have a 50 amp relay ( and are made by omega), an omega heat sink And All the relays have a thermo conductive jell between the relay and heat sink, which allows for more complete heat dissipation. ( this is an added feature that also seperates our controllers from the competition.) If you were to build this controller yourself you would spend over $750 if useing the exact same components.   Also these controllers have the relay and heatsink located in a seperate housing unit( below) this allows the control head to NOT be exposed to extreme temps. In turn allowing the controller to last a lot longer than ( even the same controller) those mounted in the same "box"  All of the controllers we sell are rated higher than what your kiln will require ( ie if you have a 110 15amp kiln ) the wires will be rated to 30 ams and the relay rated to 50 amps Also this controller can be used as a standard digital set point controller or as a ramp and soak control (both of which are very easy to use.) This controll head has dual alarm outputs should an alarm or "alarm feature" be required ( if you wish to have this wired up, it can be accomidated, however if you wish to have relays installed- this will increase the total cost (please contact prior to bidding to find out aprox cost), or you can install w/ your own relay ( at your location) If you wish to have 1 ( or both) of the alarm features wired, please contact us prior to bidding) This feature is not commonly used in the glass blowing industry Place a Bid!