6" Atlas Metal screwcutting woodworking jewelry lathe Start Price USD 600.00 Current Price USD 600.00 Time Left - Bid Count 0 Buy It Now Price - Reserve Price - Start Time Sunday, July 20, 2008 End Time Saturday, July 26, 2008 Location Camarillo, CA See more about '6" Atlas Metal screwcutting woodworking jewelry lathe ' Description THIS ITEM IS FOR PICKUP ONLY.  For auction is a MADE IN AMERICA Atlas Model 10100 6" Metal screwcutting lathe. A couple accessories included allow you to also use it for woodworking. If you compare Atlas lathes, you can tell that this is the later of the 6" Atlas model lathes by the more modern, squared-off design of the headstock and tailstock. This newer lathe is equipped with Timken roller bearings in the headstock. It comes with the following accessories: ATLAS 4" 3-JAW CHUCK,  ATLAS 4" 4-JAW CHUCK, SPRING-LOADED SAFETY CHUCK KEY, 1/2" TAILSTOCK CHUCK WITH KEY, 4-STEP DRIVE PULLEY FITS 5/8" SHAFT, DRIVE BELT, ORIGINAL ATLAS TOOL POST, EXTRA TOOL POST AND DRIVE BELT, ARMSTRONG DOUBLE OPEN END WRENCH, CUTOFF TOOL HOLDER WITH BLADE, SET OF CHANGE GEARS, TAILSTOCK LIVE CENTER, TAILSTOCK DEAD CENTER, R/H ARMSTRONG TOOL HOLDER, SET OF 5 INDEXABLE CARBIDE TIP TOOL HOLDERS, TWO GENUINE ATLAS WOODWORKING TOOL RESTS, TAILSTOCK WRENCH, 5-1/2" DIAMETER BILLET FACE PLATE, FACTORY SPINDLE RPM CHART.  Any additional accessories I find for this lathe I will throw in. Only the items in front of the lathe are for auction, the tools hanging on the wall behind the lathe are not included. The billet face plate is not a factory face plate, it is a turned steel plate about 1" thick, with a few tapped holes. With this face plate you can drill and tap holes for special fixturing jobs you may have. There is no motor included. One picture shows a crack in the headstock cover. Speeds are changed using the change gears. There is a lever that changes the direction of the leadscrew, or puts it in neutral. Payment can be Paypal, Cashiers Check, Money Order, or Personal Check. All checks must be deposited and cleared before the lathe can be picked up. It is located in Ventura County, Ca., which is about an hour North of Los Angeles.       Place a Bid!